€15.00
(tax incl.)
Julet Z509 5 pins green female to female adapter for display
Chargement des images...
Y cable for display
You may also like
Limited special offer
€84.00
(tax incl.)
€99.00
Easily add a motor cut-off to your electric bike equipped with hydraulic brakes!This hydraulic brake provides powerful, progressive braking and integrates an electric cut-off compatible with JULET 2-PIN male red...
Limited special offer
€139.00
(tax incl.)
€149.00
Easily add a motor cut-off to your e-bike equipped with hydraulic brakes!
This high-performance 4-piston hydraulic brake delivers powerful and progressive braking, and features an integrated motor cut-off sensor...
€20.00
(tax incl.)
This electric bike thumb throttle is compatible with all Bafang mid-drive motor kits and OZO electric wheel kits in 250W, 500W, and 750W configurations.
It can be installed on either the right or left side of your...
€6.00
(tax incl.)
This shunt allows to use your Bafang system without any display.
€20.00
(tax incl.)
Macthing SHIMANO MT200/MT401Adding
Motor power off brake sensor make cycling safer
Easy assembly and no change with the original brakestructure
Braking signal sensitivity is adjustable by user
Waterproof rating:...
€25.00
(tax incl.)
Cable harness Ebbus to connect your display to your OZO wheel motor with Bafang UART Protocol.
Customers who bought this product also bought:
€207.50
(tax incl.)
OZO has been manufacturing 36V PVC Lithium batteries in France since 2013 from high-end Panasonic cells with integrated BMS.
Choose the autonomy of your electric bike by choosing a 36V battery from our wide range of...
€25.00
(tax incl.)
Main wiring harness for 15A and 22A OZO controller. 9-way Julet connector.
€19.00
(tax incl.)
Pedal sensor compatible with the generic 250W controller for the repair of electric bikes.
2 models available: Integrated 12 magnets or V7 6 magnets
The V7 comes with a 6-magnet magnetic washer.
Cable length of 60...
€12.90
(tax incl.)
Y cable wire to plug 2 sensors on one entry of your Bafang motor BBS01 BBS02 BBSHD maxdrive or any system using Julet connector 3 pins.
With this cable you can plug one or two gear sensors, and plug two brake...
€79.00
(tax incl.)
OZO offers 3x different display models. The display is the screen on the ebikes handlebar. It shows all electrical and run datas such as battery state of charge, speed, distance and allows to select the assist power...
€30.00
(tax incl.)
This cable allows you to connect two batteries in parallel on one controller or to connect two controllers to a single battery.
You can also use it with OZO solar charger to charge two batteries at the same time....
Leave a review