€41.67
(tax incl.)
Gift voucher worth 50 € to 200 €
Valid for 1 year on all products on the site
Chargement des images...
Mounting pack for electric kit
For any purchase of an electric kit OZO (radiated motor + controller + accelerator or pedal crank) a mounting pack is offered to facilitate the installation of your electric kit and make it reliable.
€10.00
(tax incl.)
Reference:
000004
You may also like
Here is the content of the mounting pack:
A spiral sheath to group the wires along the frame (65cm long).
Two cable clamps to secure the controller to the frame (445mm long and 4.6mm wide).
A neoprene protection strip used to protect and fix the motor connectors (125mm long and 130mm wide unfolded). This band is elastic and fixed thanks to a Velcro tape (see photos below).
Three cable ties to secure the wires to the bike frame (200mm long and 4.6mm wide).
Three cable ties to secure the wires to the bike frame (205mm long and 2.5mm wide).
Six cable ties to secure the wires to the bike frame (100mm long and 2.5mm wide).
Two pieces of heat shrink tubing to protect the connectors (40mm long and 18mm in diameter with a reduction ratio of 3: 1).
A piece of heat-shrinkable sheath to protect the connectors (40mm long and 24mm in diameter with a reduction ratio of 3: 1).
Two Anderson clips to put on the engine connector to prevent disconnection thereof.
Two Velcro straps to attach the motor cable (rather than a rislan), this will allow you to disassemble your wheel more easily.
Velcro fastening
Two cable clamps to secure the controller to the frame (445mm long and 4.6mm wide).
A neoprene protection strip used to protect and fix the motor connectors (125mm long and 130mm wide unfolded). This band is elastic and fixed thanks to a Velcro tape (see photos below).
Three cable ties to secure the wires to the bike frame (200mm long and 4.6mm wide).
Three cable ties to secure the wires to the bike frame (205mm long and 2.5mm wide).
Six cable ties to secure the wires to the bike frame (100mm long and 2.5mm wide).
Two pieces of heat shrink tubing to protect the connectors (40mm long and 18mm in diameter with a reduction ratio of 3: 1).
A piece of heat-shrinkable sheath to protect the connectors (40mm long and 24mm in diameter with a reduction ratio of 3: 1).
Two Anderson clips to put on the engine connector to prevent disconnection thereof.
Two Velcro straps to attach the motor cable (rather than a rislan), this will allow you to disassemble your wheel more easily.
Velcro fastening
If you want different lengths and / or additional parts, please specify when ordering.
Customers who bought this product also bought:
€8.90
(tax incl.)
High power cable 8AWG 8mm2 to power any motorcycle, kart, quad, audio, car, solar, marine installation up to 60A continuous.
High temperature resistant and high flexibility.
sale by the meter
€20.00
(tax incl.)
brake sensor for road bikes.
Can fit on all Bafang middle motor BBS01 BBS02 BBSHD or Maxdrive or any system using Julet waterproof connector 3 pins
€20.00
(tax incl.)
This universal adapter allows to create new fixing points on the frame of the bike by picking up the fixings of the original bottle holder, in order to facilitate the installation of batteries frames 500Wh, 700Wh,...
Leave a review