€41.67
(tax incl.)
Gift voucher worth 50 € to 200 €
Valid for 1 year on all products on the site
Chargement des images...
Integrated PAS sensor for OZO controller 15A and 22A
Built-in integrated pedal sensor for square axle bottom brackets that have a minimum clearance of 4mm between crank and frame.
Compatible with OZO Touring and Enduro kits.
Very simple installation.
Julet three-way waterproof connector.
Pedal sensor installation instructions
€20.00
(tax incl.)
Reference:
000378
You may also like
€20.00
(tax incl.)
Kingmeter pas sensor 12 magnets with waterproof connector Julet Z309AG yellow.
Matching with all 15A and 22A OZO controllers.
câble length : 150 mm.
€9.90
(tax incl.)
12x magnets ring for pedelec sensor.
Brand : Kingmeter
Drive side and opposite side available.
For easier installation you can use our support available here
€10.00
(tax incl.)
These adapters allow to install the pagnet ring of your pedelec sensor on any bottom bracket standard.
The integrated pedal sensor is a rotation sensor very easy to install for bicycles equipped with a crankset square axis whose gap between the crank and the frame is at least 4mm.
Length of the cable: 60cm
Customers who bought this product also bought:
€12.90
(tax incl.)
This case will allow you to aesthetically fix your 15A 250W controller on the frame of your bike.
The box is installed on the vertical frame tube using two clamps.
Your frame tube should have a maximum diameter of...
€35.00
(tax incl.)
Half handle lock on type with battery gauge 36V or 48V.
The LEDs give you an idea of the remaining energy in the battery: 20%, 50%, 100%.
It incorporates a two-position switch
€25.00
(tax incl.)
Cable harness to connect your display to your OZO wheel motor.
€25.00
(tax incl.)
SHIMANO compatible 8 speed 11-34 cassette.
Tiering: 11-13-15-18-21-24-28-34
Weight: 346g
Leave a review