Filters
Parts for 250W 500W 750W hub motors kits
€25.00
(tax incl.)
Main wiring harness (Eb-bus) for 15A and 22A OZO controller working with Bafang protocol.
€20.00
(tax incl.)
This 33cm brake cut is interesting for bicycles equipped with cable brakes and / or road handlebars or for those who wish to keep their original brake handles
It is quick to install on the brake handle or caliper....
€12.90
(tax incl.)
This case will allow you to aesthetically fix your 15A 250W controller on the frame of your bike.
The box is installed on the vertical frame tube using two clamps.
Your frame tube should have a maximum diameter of...
€10.00
(tax incl.)
These adapters allow to install the pagnet ring of your pedelec sensor on any bottom bracket standard.
€20.00
(tax incl.)
Magnetic contact to activate the brake cut on your 15A or 22A system while maintaining your original hydraulic brakes.
Also compatible with all bikes equipped with a 2-way Julet connector.
Length 34cm
€9.90
(tax incl.)
12x magnets ring for pedelec sensor.
Brand : Kingmeter
Drive side and opposite side available.
For easier installation you can use our support available here
€20.00
(tax incl.)
Contact brake handle compatible with the 22A OZO controller
You can buy a right handle or a left or the pair.
Two colors available: Gray or black.
€15.00
(tax incl.)
Cable extension for electric bicycle hub motor with waterproof connector 9 Pins Julet Z910AT
Available in three lengths:
- 30cm
- 45cm
- 110cm
€10.00
(tax incl.)
Eb-bus extender for main harness on your OZO conversion kit.
exists in 3x lengths : 30cm, 80cm, 1m
€79.00
(tax incl.)
OZO offers 3x different display models. The display is the screen on the ebikes handlebar. It shows all electrical and run datas such as battery state of charge, speed, distance and allows to select the assist power...
€20.00
(tax incl.)
Kingmeter pas sensor 12 magnets with waterproof connector Julet Z309AG yellow.
Matching with all 15A and 22A OZO controllers.
câble length : 150 mm.
€20.00
(tax incl.)
The Z Frame Pack is a frame bag which is mounted on the horizontal tube at the rear. It is ideal for carrying tools, a mini pump, energy bars, a phone, a rain gear ...
Dimensions: 270 x 100 x 80mm / 10.6 x 3.9 x...
€25.00
(tax incl.)
Main wiring harness for 15A and 22A OZO controller. 9-way Julet connector.
€25.00
(tax incl.)
Cable harness to connect your display to your OZO wheel motor.
€20.00
(tax incl.)
Built-in integrated pedal sensor for square axle bottom brackets that have a minimum clearance of 4mm between crank and frame.
Compatible with OZO Touring and Enduro kits.
Very simple installation.
Julet three-way...
Displays, extension cables, pas sensors and all others parts for your OZO hub motor kit 250W 500W 750W with 15A or 22A controllers
